Category: Suzuki Tech

      Grouche Gets a New Lift Finally to the meat of the article, the installation. I used the instructions from the Rocky Road Outfitters  that came with the kit components I had ordered.  Like a kid in a candy store is the best way to describe me when all the pieces arrived at […]

        After removing the battery and cleaning up the battery tray, we found a threaded mounting boss that Suzuki put in at the factory. Using the button head screw, we installed the angled tab provided with the kit. We also found that if you add a washer to the screw it will […]

  Battery Tie Down Kit Installation With Bill Johnston Ok, you buy a replacement battery for your Zook for some added power. You figure out very quickly that the stock battery tie down bar doesn’t fit. What do you do?  You head to the local auto parts store and pick up one of those rubber […]

The complete on-line resource for Suzuki Preformance!

The complete on-line resource for Suzuki Preformance!

      with Bill Johnston Support Bra from ZOR Over the years, there have been a few manufacturers that have looked at the need for a reinforcement plate for the lower section of the soft top Samurai windshield around the wipers. Zuks Off Road has taken it a step farther by using some beefy […]

    By Jeff Pollock Calmini 2 Shackle Reversal Lift Kit I recently purchased another zook that I wanted to lift but not perform a multitude of other modifications due to lifting the vehicle. The Calmini 2 Shackle Reversal Kit does not require any steering corrections or the need to install longer brake lines. The […]

      The oil filter tools that most shade-tree mechanics are used to won’t work on a Zook oil filter, because the oil filters are much smaller than the filters on the bigger V8s. The smaller oil filter wrench was found at the local auto parts store. The old filter was removed and the […]

       The plug wire in the kit can’t be any easier to install. They are already labeled for cylinder 1 through 4. The replacement Suzuki distributor cap is made the same way, which makes it pretty difficult to get the firing order wrong. After assembling the plug wires on the new distributor cap, […]

    with Scott Rossow SkY-J Anyone? I have a new favorite vendor. Sean Conk at Low Range Offroad is the real deal. I discovered Low Range Offroad when I was researching YJ install kits for my tintop. I wanted top quality and complete front and rear kits from the same company. I did not […]