Category: Suzuki Tech

Roadless Gear’s Polyshield with Bob Norman     When building the Killer Bee this past year, one necessity that had to be put in was a new windshield (wind screen for you “pure English” folk) The old one was cracked and wiper scratched pretty bad. I didn’t want to replace it with just another piece […]

Rock Monster 6.4:1 Transfer Case Gears with Bill Johnston Going from stock transfer case gears to something lower can be as easy or as hard as you want to make it. You can get a ‘kit’ from an aftermarket manufacturer/distributor that includes gears, seals and bearings or you can just buy a complete case to […]

Rocky Road Outfitters Rear Driveshaft with Larry Harris I am playing in the Silver Lake Dunes State Park, wheeling along and it happens. Bang! from the rear of the truck, damn there goes that “U” joint again. Low gears, modified transfer case, big tires, you can see where this is going. Every time I modify […]

JackMate with Bill Johnston   Remember when you got your first Hi-Lift Jack? You figured you could do just about anything with it, right? Then you found out the ‘bolt on’ top jaw wasn’t as strong as the rest of the jack. And you found that it was easier to leave the base disconnected all […]

LED Lighting with Bill Johnston We keep piling on electrical equipment and it takes a toll on our systems. New winch needs a new battery, that new welder needs a bigger alternator, the new lighting needs…  well, needs nothing if you go with LED technology. I have five rather large, high amperage flood lights under […]

with Larry Harris JackGuard Installation This is a new product we at iZook found just before the 2001 ZookiMelt. It is one of those sure wish I would have found this years ago type products! Of course you do not think of it until you are backside deep in mud while pulling out your trusty […]

 Ideal Heated Knife By Jeff Pollock Have you ever found a tire you like but you felt it needed a few more grooves?  Now you can have it the way you want it.  Ideals Heated Knives are the answer to this question.  Tire lugs can be modified however you want with this great tool.  The […]

   With TEAM ZUKI We all know that space is very limited in a Samurai. There is enough room under the hood for an air compressor but to get the full benefit of on-board-air, you got to have an air tank too. Since I wanted to be able to seat a bead and run air […]

  ARB Air Lockerwith Larry Harris     The long anticipated Air Locker is now available. ARB has recently released the production model for the Suzuki Samurai. This unit has been tested around the world in some of the toughest conditions imaginable.  I have had mine installed for over two months and can tell you […]