0 0
Read Time:2 Minute, 4 Second

 

Click Here To Visit  

Another iZook Product ReviewABS Interior Replacement Panelswith Bill Johnston photos by Bryan Greaves

Click through...If keeping the outside of a Samurai looking decent isn’t hard enough, try keeping the interior looking good. The interior panels warp quickly and the vinyl covering tears even quicker. I have looked for a nice set of replacement panels at an affordable price for some time now and I finally found what I needed. A five panel replacement panel set from Designs of Steel made the upgrade fast, easy and affordable.

Click through...Click through...My 88.5 Samurai looked pretty decent when I got it, but the interior really showed its age. The rear panels were so warped and water damaged that they were removed shortly after I got the vehicle. The door panels were only torn, so they stayed for a bit longer. Click through...Click through...We had the interior sprayed with a bed liner compound the year before, but it still lacked something. So we looked for something to cover up the empty space. Click through...Click through...The complete set comes with two door panels, two rear/side panels and the tailgate panel. It also comes with two sizes of push-in nylon fasteners. This makes it easy to install without drilling or screwing the panels down. Click through...Click through...The fasteners use the stock mounting holes, so you don’t need to pull out the power tools. Click through...Click through...We had installed some aftermarket speaker pods made for the Samurai, so they had to be removed before dropping in the side panels. The grab handles also have to be removed, but the panels are already drilled to allow you to replace them after the panel is installed. Click through...Click through...One of the stock fastener locations happens to be behind the roll bar. We found it just about impossible to push in the fastener here, but once the grab handles were installed the panel looked fine.

Click through...Click through...Click through...Click through...

The door panels required a little more work as you have to remove the hardware with a screwdriver first.

Click through...Click through...Click through...Click through...

Pulling the torn panel and replacing it with the new ABS panel is fast and easy. And as you can see, it certainly makes a nice, clean look.

Click through...Click through...Click through...Click through...Click through...

The manufacturer of this package normally creates works of art in steel, as you can see on their web site. But check out their ABS Plastic Panels page to find out about their panel kits. When you order, tell them iZook sent you. Source:

Designs of Steel P.O. Box 1001 Perkins, OK 74059amy@designsofsteel.com

08/11/10 15:07

[tech/footer.htm]

Happy
Happy
0 %
Sad
Sad
0 %
Excited
Excited
0 %
Sleepy
Sleepy
0 %
Angry
Angry
0 %
Surprise
Surprise
0 %

Average Rating

5 Star
0%
4 Star
0%
3 Star
0%
2 Star
0%
1 Star
0%

Leave a Reply