0 0
Read Time:2 Minute, 38 Second

Wrenchin' with IZookwith Bill Johnston

Redesigning the ARB

You’re on a really wild trail, you have wacked the pumpkins a few times but all seems to be fine. You get your front end up on a radical waterfall… and then you hear it! The dreaded hiss of an air leak coming from somewhere underneath the vehicle. Your spotter checks the tires, no problems. Then he tells you that a front tire is not turning… the locker isn’t engaging! He checks the air lines and they are fine – the leak is inside the differential housing! Uh-oh…

Click through for a closer look...Click through for a closer look...The most common air leak for an ARB is when the line gets snagged on something underneath and it rips the line. There are kits available on the market to keep in your glove box to quickly remedy that problem. But what happens when you can’t get to the leak  because it is inside the differential? Click through for a closer look...Three screws are installed with loc-tite, but if you over-torque the screws you can deform the clamping plate and it will result in a failure (the plate to the left is supposed to be flat…). During installation, you do not see the plate, so unless you are very careful with the torque wrench you won’t know there is a problem until it fails. As we all know, this will almost always happen at the wrong moment. Click through for a closer look...Click through for a closer look...The fix is a new type of seal housing that uses a heavy duty spring clip to hold it in place. The components on the left will now be replaced by the components on the right. The original components are still very viable parts, and they will work very well for the life of your locker. But if the installation was faulty (and you won’t know until it fails) then having the updated components will give you more confidence in your equipment. Click through for a closer look...Click through for a closer look...Instead of a cast component, the new housing looks machined to spec. It has locating notches instead of screw holes and it has a lip that will retain the spring clip under pressure. Click through for a closer look...Click through for a closer look...With the spring clip installed, you can see how it grips the large adjuster nut on the left. A more detailed drawing on the right is provided by ARB. You can see how much easier the installation goes because at this point you only have to use the screwdriver to pull the clip over the lip.

Click through for a closer look...Click through for a closer look...Click through for a closer look...

If you have never installed or serviced an ARB Air Locker, you are probably confused about how all this works. But if you have had any experience with these lockers you are probably jumping for joy right about now… Here is a table to help you get the parts you need. *NOTE*In addition, upgrading from a screw secured seal housing to a spring clip secured housing will require fitment of the ‘3.5mm O-ring Bulkhead Kit’ (Part No. 170105) due to the 3.5mm copper tube used on the spring clip secured seal housings. Component Source:

ARB Corporation LimitedAir Locker Inc. 20 South Spokane Street Seattle, WA  98134 Tel: 1-206-264-1669 Email: sales@ARBUSA.com

 

08/11/10 15:15:23

 

Happy
Happy
0 %
Sad
Sad
0 %
Excited
Excited
0 %
Sleepy
Sleepy
0 %
Angry
Angry
0 %
Surprise
Surprise
0 %

Average Rating

5 Star
0%
4 Star
0%
3 Star
0%
2 Star
0%
1 Star
0%

Leave a Reply