0 0
Read Time:46 Second

 

 

 

 

Wrenchin' with IZookwith (TD) Troy Graham

Rotary Engine Install: Part 1, Page 5

The shifter base sits at the very rear of the tranny, so I had to do a little creative work with a sheet metal nibbler. However, as close as it looks, everything still works, BARELY. To avoid any hassles, the transfer case shifter will have to be bent slightly:

And another view from the side:

You need to use the slip yoke from the RX-7, but I found a little suprise: Mazda started crimping in their u-joints sometime between 81 and 85, so I had to get a drive shaft at the junkyard even though the one that came out of my 85 was in great shape. The “crimped” in style shaft is at the top, and the style with the internal snap rings is at the bottom:

 

08/11/10 15:20

 

 

Happy
Happy
0 %
Sad
Sad
0 %
Excited
Excited
0 %
Sleepy
Sleepy
0 %
Angry
Angry
0 %
Surprise
Surprise
0 %

Average Rating

5 Star
0%
4 Star
0%
3 Star
0%
2 Star
0%
1 Star
0%

Leave a Reply